<aside> 🔧 This is the build guide for the Sofle Choc Kit from https://choc.brianlow.com/

</aside>

What you will need for this step

For one half:

• 1 x reset switch
• 1 x TRRS connector
• 1 x encoder
• Soldering iron and solder

Solder misc components

These components are installed on the top of the PCB.

Use tape to tack each component in place while flipping the board over to solder.

Solder the reset switch. Orientation does not matter.

Solder the TRRS connector. You may need to bend the TRRS connector pins 90 degrees so they point down into the PCB. One side of the connector has a single leg, this leg should fit into a through hole farthest away from the edge of the board

The R1 and R2 locations should remain empty. These are needed if you want to use I2C communications between halves (requires firmware changes).

Solder the encoder.

Next step

Assembly